An All-Inclusive Guide to Fix Not Working Issue

An All-Inclusive Guide to Fix Not Working Issue

Whether you want to hide the network name of your Netgear wireless range extender or change its default password, it is required that you access However, if that is exactly what you are unable to do, then, unfortunately, you are in big trouble. But, worry not. Like every problem, this one is temporary too. 

Walkthrough the troubleshooting hacks mentioned in this post and learn how to log in to your Netgear extender hassle-free via and tweak its settings. 

Fixed: Not Working Issue

  1. Reboot Your Netgear Extender

Start troubleshooting the not working issue by rebooting your Netgear WiFi range extender. Here’s how you can give your device a restart:

  • Disconnect your client devices from the extender’s Netgear_ext.
  • Turn off your Netgear range extender and unplug it from its power socket.
  • Wait for a couple of seconds.
  • Thereafter, plug your Netgear range extender back into its wall socket.
  • Turn on your device.

Now, check whether you are able to log in to your Netgear extender via or not. If not, continue reading.

  1. Verify the Ethernet Connection

There is a possibility that your Netgear range extender and home router are not properly connected. And that might be because the Ethernet cable connecting your devices has cuts on it.

To get the issue fixed, consider getting your cable replaced with a new one. If you want to take the easier route, connect your devices using a wireless source.

  1. Use the Correct Web Address

Perhaps, you didn’t pay attention while entering the default web address of your Netgear wireless extender. Thus, next time you try to log in to your device, make sure that you are typing the correct web address in the address bar of your internet browser.

Also, make sure that if you are using a Mac device, access mywifiext local instead of mywifiext net. The reason being, mywifiext net is not compatible with Mac devices.

  1. Update Your Web Browser

An outdated web browser is also one of the major reasons why you are going nuts because of the not working issue. 

Therefore, head over to the Settings menu of the web browser you are currently using, and select the Upgrade button to update it to its latest version.

  1. Disable Antivirus Software

Yes, antivirus software secures your WiFi-enabled devices from potential threats. But, at times, it can also prevent you from accessing certain websites, including

To troubleshoot the issue, disable the antivirus software on your device temporarily. Once done, try to log in to your Netgear wireless range extender. Any luck this time?

  1. Reset Your Netgear Extender

If you are still not able to log in to your WiFi device using the default web address, then it is high time that you perform factory default reset.

Caution: Resetting your Netgear range extender will restore all its settings to the default mode. In simple words, every change that you have made to our device till date will get erased forever.

Follow the guidelines mentioned below and get to know how to restore your device to the factory default settings:

  • Look at all sides of your Netgear range extender and find the Reset hole.
  • Take an oil pin and carefully insert it in the Reset hole.
  • Wait for a few seconds.

In some time, your device will get restored to its default mode, presenting you with a chance to set it up from scratch.

Note: Whether you have performed Netgear EX6100 setup or configured any other extender model in your home, the process of factory default reset will remain the same.

Summing Up

With that, our guide to troubleshoot the not working issue has come to an end here. Let us hope that you will be able to get rid of the not working issue after following the hacks mentioned in this post. 

Now, you are free to hide the network name of your Netgear wireless range extender, change its default password, or do pretty much anything that you want to do with it.

Pooja Saxena